112 Section 3A: Sprint PCS Vision—The Basics
3. On your smart device press Start and select
Programs.
4. Select Modem Link .
5. Press OK to dismiss the message Modem Link.
6. Select the Connection list, and then select USB.
7. Press Activate (left softkey).
8. Once the Sprint PCS Connection Manager
software has been fully installed on your PC, and
the Modem Link application is activated on your smart device, connect your
device to your computer using the sync cable. (When your computer detects
the connection, an icon is displayed in the taskbar in the lower-right
corner of your computer screen.)
9. On your computer, open the Sprint PCS Connection Manager software, select
your device name, and then click Connect.
10. Once the connection is established, launch an Internet session, check your
email, or do anything else you would do using a traditional Internet
connection.
11. When you’re ready to terminate the Internet connection, double-click the
Sprint PCS Connection Manager icon in the taskbar in the lower-right
corner of your computer screen, and then click Disconnect to end the
session.
Note:
If neither icon appears, you cannot use your device as a modem with Sprint PCS
Connection Manager.
To Next Page
Loading...
