Section 6B: Customizing Your Smart Device 307
Customizing
8. Select the 802.1x tab, and then set the following
if available (the settings vary based on your
settings on the other tabs and on the supported
features of your Wi-Fi SDIO card):
䡲 Use IEEE 802.1x network access control: Lets
you set these parameters if required by the
network.
䡲 EAP type: Specifies the extensible
authentication protocol type.
9. Press OK .
Selecting a Wi-Fi Network
After you set up a Wi-Fi connection, it’s easy to connect to that network. If you
have access to multiple Wi-Fi networks, you can select which network you want
to connect to.
1. Wake up your smart device’s screen (see “Waking Up the Screen and Turning
It Off” on page 19), and then insert the Wi-Fi card into the expansion slot
(see “Removing and Inserting Expansion Cards” on page 269).
2. Tap Wi-Fi in the title bar.
3. Select the Settings link.
Did You
Know?
You can conserve battery power by removing the Wi-Fi card or turning off
a Wi-Fi connection when you are not planning to use it for an extended
period.
To Next Page
Loading...
