SECTION 400 (Version3.0)
Issue 1 January 1990
DBS
FF-1 System mode
FFl-2#-3#-16#-(1 - 3)#
Automatic pause position
for
each dial -
Dial 8
Same as (FFl-2#-3#-(1 - 3)#).
It is specified after
which digit dialed there should be
a
pause having
made a connection with an outside line of the
system and then dialing 8.
[CONFI#: No automatic cause after dialina 8
_ l#: Automatic pause at 1st digit after dialing 8
t#: Automatic pause at 2nd digit
afkerdialing
8
3#: Automatic pause at 3rd digit
after
dialing 8
FFl-2#-3#-17#-(l- 3)#
Automatic pause position for each dial -
Dial 9
Same as (FFI-t#-3#-(l- 3)#). It is specified after
which digit dialed there should be a pause having
made a connection with an o&de line of the
system and then dialing 9.
ICONFI#: No automatic oause after diaiino 9
1 B: Automatic pause at 1st digit after dialing 9
2#: Automatic pause at 2nd digit after dialing 9
3%: Automatic pause at 3rd digit after dialing 9
FFl-2#-3#-18#-(1 -3)#
Automatic pause position
for
each dial -
Dial 0
Same as (FFl-2#-3#-(1- 3)#). It is specified after
which digit dialed there should be
a
pause having
made a connection with an outside line of the
system and then dialing 0.
ICONFl#: No automatic pause afterdialino 0
1 #: Automatic pause a! 1 St digit after dialing 0
2#: Automatic pause at 2nd digit after dialing 0
3#: Automatic pause at 3rd digit after dialing 0
FFl-2#-4#-1 B-(0 or l)#
Control ring patterns for UNA
control
terminals
(M, c B)
When using UNA (Universal Night Answer), the
operating specifications for each of the relay
controlled terminals
are
determined. When
utilizing a sound source for the buzzer, etc., ” 1 set
on/3 set off’ is selected.
When operating with the pattern set, it is
connected from terminal C to terminal M or
released from terminal C to terminal 8. This
setting is only effective when UNA is operating for
incoming calls on outside lines.
Note
: Ext pan 73 is ringing
assignment for IJ NA
terminal (FF4-l#, FF4-2#)
OR: 3 secl 1 set interval
l#: Continuously
FFl-2#-4#-2#-(0 9r l)#
EPI control when paging - #OO
It is set whether the EPI (External Page tnterface)
is to be used when calling paging group #OO.
0%: No EPI relay ooeration when callina oaainq
grouD 00
l#: EPI relay operation when calling paging
group 00
FFl-2#-4#-3#-(0
or 1)#
EP1 control when paging - #Ol
It is set whether the EPI (External Page Interface)
is to be used when calling paging group #Ol.
O#: No EPI
relay
operation when callina oaoinq
arouo 01
I#: EPI relay operation when calling paging
group 01
-19-
To Next Page