35
Additional Information
on Operation
Setting Item
Factory Default Value
Description
1
Rec/Play Recording and Playback Settings
PowerOff Time
∗
1
120 Time from the SIGNAL turn-off to recorder
shut-down (minutes)
Setting :
0, 10, 20, 30, 60, 90, 120, 180,
AUTO
∗
2
Init Camera
Select
1 Initial video input selection (upon power on)
Setting :
1 ([CAMERA1] connector input)
2 ([CAMERA2] connector input)
LAST
∗
3
Init Audio2 In
Select
INCAR Initial source selection for Audio2 input
(upon power on)
Setting :
INCAR ([IN CAR MIC] connector input)
WMIC
∗
4
([AUDIO IN 2] connector input)
LINK CAM
∗
5
LAST
∗
3
PowerOn Rec OFF Automatically start recording with power-on
Setting : ON, OFF
Loop Rec OFF Loop recording
Setting : OFF fixed
Intermittent Rec OFF Intermittent recording
Setting : ON, OFF
Resolution/
RecRate
Q-512k Recording resolution and bit rate
Setting : Q-512k (320x240 pixel, 512 kbps)
Q-1M (320x240 pixel, 1 Mbps)
F-1M (720x480 pixel, 1 Mbps)
F-2M (720x480 pixel, 2 Mbps)
F-1M is 10 fps, and others are 30 fps
∗1 Depending on the vehicle, the battery may run out of power during operation.
∗2 When recorder operation is not controlled by a PC application:
Power is turned off immediately. Note, however, that power is not turned
off while data is exported to a USB memory device, but is turned off after
completion of data export.
When recorder operation is controlled by a PC application:
Power is turned off when control from a PC application is released, or when
the PC card slot cover is opened.
∗3 Applies the setting in effect when power was last turned off. Unless power is
turned off properly, the operating state may not be saved correctly.
∗4 WMIC is the abbreviation for Wireless Microphone.
∗5 In LINK CAM mode, being linked with the change of camera, Audio2 sound
input changes. Changing to the [CAMERA1 (CAMERA2)] connector input,
sound comes from the [AUDIO IN 2 (IN CAR MIC)] connector input.
Setup
(continued)
Items administrators can set:
(Continued on the next page)
To Next Page
Loading...
