36
Setting Item
Factory Default Value
Description
1 Rec Continue
Time
CONTINUE Continuous recording time (minutes)
Setting : 1, 2, 5, 10, 15, 20, 30, 60, 90,
CONTINUE
PreRec Time
(Video)
90 Video Prerecord time (seconds)
Setting : 0, 10, 20, 30, 60, 90
PreRec Time
(Audio)
90 Audio Prerecord time (seconds)
Setting : 0, 3, 10, 20, 30, 60, 90
PostRec Time
(Video)
90 Video Postrecord time (seconds)
Setting : 0, 10, 20, 30, 60, 90
PostRec Time
(Audio)
90 Audio Postrecord time (seconds)
Setting : 0, 3, 10, 20, 30, 60, 90
Rule of
Filename
WT Recording file naming method
Setting : WT(World time)
LT(Local time)
Init Audio2 Rec ON Initial on/off setting for Audio2 input (upon
power on)
Setting : ON, OFF, LAST
∗
2
Init On Screen
Type
OFF
Initial OSD (on-screen display) overlay setting
Setting : AUTO, SIMPLE, DETAILS, LAST
∗
2
,
OFF
GPIO9 for Rec ENABLE Select recording status output to GPIO9
Setting : ENABLE, DISABLE
GPIO9 for Error ENABLE
Select recording error status output to GPIO9
Setting : ENABLE, DISABLE
Init Audio Out
(Play)
BOTH
Initial audio output selection (upon power on)
Setting : OFF, 1, 2, BOTH, LAST
∗
2
Play Mode SINGLE
Select playback mode (relay playback setup)
Setting : SINGLE, RELAY
Skip Target Skip position
Trigger/Marker
YES Select a trigger or marker location
Setting : YES, NO
Head of File YES Select the starting point of the file
Setting : YES, NO
2 Programed Rec
Programmed recording setting
Daily –
Programmed recording for every day
Setting : –, ON
(Setting “–” will disable start and stop time settings)
Mon to Sun –
Programmed recording setting on a specific
day of the week (Monday to Sunday)
∗
4
Setting : –, ON
(Setting “–” will disable start and stop time setting
s
)
∗2 Applies the setting in effect when power was last turned off. Unless power is
turned off properly, the operating state may not be saved correctly.
∗4 When [Daily] is set to “ON”, [Mon to Sun] cannot be set.
Setup
(continued)
To Next Page
Loading...
