Panasonic AG-CPD15P - Page 38

38
Setting Item Factory Default Value Description
Detection H
Method for trigger signal (GPIO1-8) detection.
Choice of signal detection depends on set
[Action].
• In REC, CAM1REC and CAM2REC modes
Setting : H (high-edge trigger),
Level H (high-level trigger),
L (low-edge trigger),
Level L (low-level trigger),
B (both-edge trigger)
•
In CAM1, CAM2 CAM1LED, AUTOZOOM and
STOP modes
Setting : H (high-edge trigger),
L (low-edge trigger),
B (both-edge trigger)
• In NONE mode
Setting : H (high-edge trigger),
L (low-edge trigger),
SPEED
(vehicle speed pulse, GPIO8 only)
4
Printable OFF Character definition when one letter is
displayed in the OSD
Setting : A - Z, –, OFF
5 OSD Embedded OSD (On Screen Display)
OSD ON OSD on/off setting
Setting : ON, OFF
Display Position L-Upper Location display setting
Setting : L-Upper (upper left),
R-Upper (upper right),
L-Bottom (bottom left),
R-Bottom (bottom right)
Trigger ON OSD setting during trigger signal (GPIO1-8)
input
Setting : ON, OFF
Time ON Date and time display setting
Setting : ON, OFF
Source@Area OFF Display setting for the vehicle identification
and name of a location
Setting : ON, OFF
Setup
(continued)