39
Additional Information
on Operation
Setting Item
Factory Default Value
Description
6 Camera
Color Camera setting
Zoom Limit 22 Maximum zoom magnification
Setting : 22, 220
AGC Level HIGH
Color Camera automatic gain control setting
Setting : LOW, MID, HIGH, OFF
Init Backlight OFF Initial backlighting compensation setting
(upon power on)
Setting : ON, OFF, LAST
∗
2
(perform backlighting compensation
when on)
Init AE Shift 0 Initial exposure compensation of Color
Camera video (upon power on)
∗
5
Setting : -2, -1, 0, +1, +2, LAST
∗
2
Flip OFF
Color Camera image top/bottom flip enable/
disable
Setting : ON (Top/bottom flip enabled),
OFF (Top/bottom flip disabled)
AutoZoom
Magnification
10 Magnification of auto zoom
Setting : 1, 2, 3, 4, 5, 7, 10, 15, 22
AutoZoom Time 3 Auto zoom magnification retention time
(seconds)
Setting : 3, 5, 8
Init Camera LED ON Initial Color Camera [REC] lamp enable/
disable setting (upon power on)
Setting : ON ([REC]lamp lights during recording),
OFF
([REC]lamp does not light),
LAST
∗
2
Init IR Mode AUTO IR switching function
Setting :
AUTO
(Automatically switch IR
function on/off),
OFF (Force IR function off),
ON (Force IR function on),
LAST
∗
2
IR Level LOW IR auto switching level setting
∗
6
Setting : LOW, HIGH
IR Time 30 IR auto switching level detection time
(seconds)
∗
6
Setting : 10, 30, 60, 300
∗2 Applies the setting in effect when power was last turned off. Unless power is
turned off properly, the operating state may not be saved correctly.
∗5
When the [Init AE Shift] setting is “+2” and the target is dark, the image may not
refresh at 30 frames/sec.
∗6
The [IR Level] and [IR Time] settings apply only when the [Init IR Mode] setting
is “AUTO”.
Setup
(continued)
(Continued on the next page)
To Next Page
Loading...
