Panasonic AG-CX350 - Page 87

– 87 –
Chapter 4 Operation — Menu settings
[OFF] Does not superimpose.
(Factory setting: [OFF])
[HDMI OUT ZEBRA]
Sets whether to superimpose the zebra signal to the output from the <HDMI> terminal. The settings of the zebra signal follow the zebra signal settings
in the [VIDEO OUT/LCD/VF] menu → [EI ASSIST].
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [OFF])
@@
NOTE
t The setting is xed to [OFF] when the [SYSTEM] menu → [COLOR SETTING] is set to [V-Log].
[HDMI OUT HDR]
Sets the output image from the <HDMI> terminal.
[SDR] Outputs in the standard dynamic range.
[HDR] Outputs in the high dynamic range.
(Factory setting: [HDR])
@@
NOTE
t The setting is xed to [SDR] when set to following menu.
‑ [SYSTEM] menu → [REC FORMAT] → [480-59.94i/AVCHD SA]
‑ [SYSTEM] menu → [REC FORMAT] → [576-50.00i/AVCHD SA]
‑ [VIDEO OUT/LCD/VF] menu → [HDMI OUT] → [OUT FORMAT] → [720×480p]
‑ [VIDEO OUT/LCD/VF] menu → [HDMI OUT] → [OUT FORMAT] → [720×576p]
t When the [SCENE FILE] menu → [GAMMA MODE SEL] is set to anything other than [HLG], the camera image is output in the standard dynamic
range.
t This cannot be set when the [SYSTEM] menu → [COLOR SETTING] is set to [V-Log].
[HDMI OUT V-Log]
Sets the output image from the <HDMI> terminal when the [SYSTEM] menu → [COLOR SETTING] is set to [V-Log].
[V‑Log] Outputs in same color as the recording image.
[V-709] Outputs in a converted color equivalent to standard CINE-LIKE. Setting suitable for a preview.
(Factory setting: [V-Log])
@@
NOTE
t The setting is xed to [V-709] when set to the following menu.
‑ [SYSTEM] menu → [REC FORMAT] → [480-59.94i/AVCHD SA]
‑ [SYSTEM] menu → [REC FORMAT] → [576-50.00i/AVCHD SA]
‑ [VIDEO OUT/LCD/VF] menu → [HDMI OUT] → [OUT FORMAT] → [720×480p]
‑ [VIDEO OUT/LCD/VF] menu → [HDMI OUT] → [OUT FORMAT] → [720×576p]
t This cannot be set when the [SYSTEM] menu → [COLOR SETTING] is set to [NORMAL].
[AV OUT]
[OUTPUT SW]
Enables/disables the output from the <AV OUT> terminal.
[ON] Outputs the video and audio.
[OFF] Does not output the video and audio.
(Factory setting: [ON])
[AV OUT CHAR]
Sets whether to superimpose the character to the output from the <AV OUT> terminal.
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [ON])
[AV OUT ZEBRA]
Sets whether to superimpose the zebra signal to the output from the <AV OUT> terminal. The settings of the zebra signal follow the settings in the
[VIDEO OUT/LCD/VF] menu → [EI ASSIST] → [ZEBRA].
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [OFF])