Panasonic AG-HMC150P/AN - Display of ZOOM MOTOR Operation Number of Times; SHUTTLE SPEED Select; Update

INF-10
4-1-5. Display of ZOOM MOTOR operation number of times
Driving times of Zoom Motor is displayed. (Operation number of times is displayed by every100 times)
Note: Driving times of zoom motor can be confirmed also with the Setting Tool screen (PC EVR software:
VVS0070). Please refer to item “5-4-5. Display of ZOOM MOTOR operation number of times (CAM(C
)
section)” (Page INF-20)
4-1-6. SHUTTLE SPEED Select
Shuttle speed can be changed.
1. Tilt the OPERATION lever in the ▲▼ direction to select the “SHUTTLE SPEED”, and press the OPERATION
lever (or tilt lever in ► direction).
2. Tilt the OPERATION lever in the ▲▼ direction to select the “x4 or x16”. And press the OPERATION lever to
value is fixed. (Factory setting is set to x4)
4-1-7. Update
This item is only use at factory. Don’t execute the item UPDATE!. If UPDATE is executed, camera recorder can not
operate.
DIAGNOSTICS MENU 2/2
ERROR RESET
NO
SERVO ZOOM
000200T
SHUTTLE SPEED
x4
UPDATE
NO
SETUP ENTER EXIT
MENU
DIAGNOSTICS MENU 2/2
ERROR RESET
NO
SERVO ZOOM
000200T
SHUTTLE SPEED
x4
UPDATE
NO
SETUP ENTER EXIT
MENU
DIAGNOSTICS MENU 2/2
ERROR RESET
SERVO ZOOM
SHUTTLE SPEED
x4
UPDATE
x16
SETUP ENTER EXIT
MENU
ZOOM MOTOR operation number of times is displayed
DIAGNOSTICS MENU 2/2
ERROR RESET
NO
SERVO ZOOM
000200T
SHUTTLE SPEED
x4
UPDATE
NO
SETUP ENTER EXIT
MENU