Panasonic AG-HMC150P/AN - Setup for PC EVR Software

INF-22
5. Connect the USB cable between camera recorder and PC.
6. “Found New Hardware Wizard” automatically opens on PC. Install it according to the message.
6-2-2. Setup for PC EVR Software
1. Download the file “PC EVR Software for AG-HMC150 series (VVS0069)” from Global Service WEB Site.
2. Turn the power on and confirm camera recorder is set to CAM mode.
3. Hold down “STOP (Tilt the Operation lever in the ▼directions)”, “EXEC” button and “WFM” button
simultaneously for at the three seconds to set COM mode. (The letter of “COM” blinks to the LCD screen when
the COM mode is set.)
NOTE: To cancel the COM mode, execute the operation of the same button as the setting. (Com mode cannot be
cancel if the power has been switched off and back on again)
4. Connect the USB cable between camera recorder and PC.
5. Start up the PC EVR software by double-click “VVS0069.exe”.
Mini-B
USB cable
A type
COM
The letter of “COM” (red color)
blinks to the LCD screen when the
COM mode is set.
EXEC button
OPERATION Lever
WFM button
Mini-B
USB Cable
A type