INF-17
5-4. Setting Tool screen
This PC EVR software has Setting Tool screen in “SYSCON(S)" and the “CAM(C)" section. The operation
number of times of ZOOM MOTOR can be reset on the Setting Tool screen on the “CAM(C
)" section.
< How to display the Setting Tool screen. >
1. Select “SYSCON(S)” or “CAM(C)” section after start up the PC EVR software, and click “OK” button.
2. Select “Setting Tool” in “Tools(W
)” menu, Setting Tool screen will appear on screen.
< Function of the Setting Tool screen. >
The following confirmation and the setup can be performed on a Setting Tool screen.
● Setting and confirmation of Date and Time of internal clock.
● Hour Meter display (operation hours).
● Software version display (CAM/SYS).
● Power supply reboot.
● Display and reset of ZOOM MOTOR operation number of times (“CAM(C
)" section).
Setting and confirmation of
Date and Time of internal clock
Software version display.
Hour Meter display
(operation hours)
Power supply reboot.
*Only AG-HPG10 is used.
*Not used
*Only AG-HPG10 is used.
*Not used
*Not used
*Not used
To Next Page
Loading...
