INF-21
6. PC EVR software (VVS0069)
6-1. Required tools and equipment for PC EVR software
When the PC EVR software is used, the following tools are required.
NAME Part Number Pcs. Remark
PC EVR
software
VVS0069 1
Download from the Global Service WEB site.
USB driver VVS0058 1
Download from the Global Service WEB site.
Same driver as DVD-CAM, DVC-CAM
USBC cable A type ↔ mini B --- 1
Personal Computer
--- 1
*NOTE:
*OS: Windows XP SP2
6-2. Setup
6-2-1. Installation method of USB driver (VVS0058)
This work is not necessary if USB driver for DVD/DVC-CAM adjustment has already installed.
1. Download the file “USB Driver for Adjustment (VVS0058)” from Global Service WEB Site.
2. After extracting VVS0058.zip, execute “USB_COM.exe” in VVS0058.
3. Execute “setup.exe” in “ComMass” folder. Install it according to the message.
4. This camera recorder is set to COM mode.
< Setting method of COM mode >
4-1. Turn the power on and confirm camera recorder is set to CAM mode.
4-2. The COM mode is set by hold down the “STOP (Tilt the Operation lever in the ▼directions)”, “EXEC”
button and “WFM” button at the same time for three second or more. (The letter of “COM” blinks to the LCD
screen when the COM mode is set.)
NOTE: To cancel the COM mode, execute the operation of the same button as the setting. (Com mode cannot be
cancel if the power has been switched off and back on again)
COM
The letter of “COM” (red color)
blinks to the LCD screen when the
COM mode is set.
EXEC button
OPERATION lever
WFM button
To Next Page
Loading...
