INF-4
3. Lithium battery
3-1. Replacement Procedure
1. Remove the Side Case R S Ass’y.
2. There is a Lithium battery on the RSIDE P.C.Board.
3. Unsolder the each soldering point of electric lead terminal for Lithium battery “Ref No: B1400 at foil side of
RSIDE P.C.BOARD) and remove the Lithium battery together with electric lead terminal.
4. Install the new battery.
5. Set the date and time of internal clock (Refer to item “Setting the Calendar” of operation instructions for the
setting method).
NOTE: A setup date and time of internal clock can be set also on PC EVR software (refer to item “5-4-1.
Setting and confirmation of Date and Time of internal clock(SYSCON(S
) section)” and item
“6-3-3. Setup of Date and Time of internal clock”).
< NOTE >
Do not pick up the lithium battery and electric lead terminal
with tweezers.
When you use tweezers, use the things of non-conductivity.
Do not put soldering iron to simultaneous (+) and (-) terminal.
Do not touch the (+) and
(-) electric lead terminal.
It fixes with adhesives.
RSIDE P.C.Board
SIDE CASE R S Ass’y
LITHIUM BATTERY
To Next Page
Loading...
