INF-3
2. Maintenance
2-1. Maintenance Schedule
No. Part Name Part No. Pcs Replacement
1 Zoom Motor Unit L6DABBKC0001 1 Every 100,000 number of times (SERVO ZOOM)
*
Please refer to the following procedures.
2-2. Confirmation method of operation number of times
The operation number of times of Zoom Motor is displayed on item SERVO ZOOM in DIAGNOSTICS menu
screen.
1. Push the button in order of “RESET/TC SET” button → “STOP” button → “DISP/MODE CHK” button →
“MENU” button.
NOTE: “STOP” button = Push the OPERATION lever in the ▼ direction.
2. Push the OPERATION lever in the ▲ or ▼ direction to select the DIAGNOSTICS menu. And push the
SET(STILL) button to open the DIAGNOSTICS menu.
3. Push the OPERATION lever in the ▲ or ▼ direction to display the item “SERVO ZOOM”.
The operation number of times can be confirmed also with the PC EVR software. Please refer to < Display of
operation number of times > of item “5-4-5. Display of ZOOM MOTOR operation number of times” about
display procedure by PC EVR software (page INF-20).
2-3. Reset of operation number of times
After replacing Zoom Motor unit, set the operation number of times to 0 times.
Please refer to < Setting of operation number of times > of item “5-4-5. Display of ZOOM MOTOR operation
number of times” about setting procedure by PC EVR software (page INF-20).
2-4. Replacement procedure of Zoom Motor unit
The removal procedure has been described to the item “12. Removal of Zoom Motor Ass’y” of disassembly
procedure (SECTION 2).
DIAGNOSTICS 2/2
ERROR RESET
NO
SERVO ZOOM
000200T
SHUTTLE SPEED
x4
UPDATE
NO
SETUP ENTER EXIT
MENU
The maintenance execution time shown in the above is recommendation for standard maintenance execution.
This is not life of various parts. The life is influenced by temperature, humidity, dust, etc..
The operation number of times of the zoom
motor of the lens unit is displayed.
NOTE: The operation number of times is
displayed by every 100 number of
times.
To Next Page
Loading...
