- 154 -
When [ON] is selected, the Image Stabilizer works with customized [BLUR AMPLITUDE] and
[BLUR FREQUENCY] settings. (l 50)
This sets the blur amplitude of the Image Stabilizer during recording. (l 50)
This sets the blur frequency of the Image Stabilizer. (l 50)
When you press the WHITE BAL button, you can assign ATW.
This fine-adjusts the intensity of red. (l 62)
≥ This function’s default setting is “0”.
This fine-adjusts the intensity of blue. (l 62)
≥ This function’s default setting is “0”.
[CUSTOM O.I.S.]
[ON]/[OFF]
[BLUR AMPLITUDE]
[1]/[2]/[3]/[4]/[5]
[BLUR FREQUENCY]
[1]/[2]/[3]
[ATW SET]
[OFF]: Does not assign ATW when the WHITE BAL button is pressed.
[Ach]: Sets the White Balance mode to ATW when the WHITE BAL button is pressed to
switch to
[
Ach
]
.
[Bch]: Sets the White Balance mode to ATW when the WHITE BAL button is pressed to
switch to [Bch].
[PRST]: Sets the White Balance mode to ATW when the WHITE BAL button is pressed to
switch to [PRST].
[ATW TARGET R]
[ATW TARGET B]
AG-UX90EJ_DVQP1150ZA.book 154 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分
To Next Page
Loading...
