- 61 -
About White Balance modes
*1 This setting is selected automatically when one of the following operations is performed:
j Set [ATW] to [ON] and switch to Auto Mode. (l 44)
j Press the USER button to which [ATW] is registered. (l 79, 84)
j Pressing the WHITE BAL button to switch to the item (Ach/Bch/PRST) setting in [ATW SET]
(l 154)
*2 You can set this mode with a USER button.
≥ In the following cases, even if you press the USER button to which [ATW] is registered or press
the WHITE BAL button, the White Balance mode cannot be changed:
j In Auto Mode with [ATW] set to [ON]
j During Freeze Frame (l 86)
≥ Changing the settings in [RB GAIN CONTROL SETTING] allows you to fine-adjust the color
balance settings of [Ach] and [Bch]. (l 142)
Mode Settings
ATW (ATW)
*1
It will automatically adjust in accordance with the recording condition.
LOCK
(ATW Lock)
*2
It will lock the setting for ATW. (l 62)
P3200K
(P3200K)
Preset value for studio/indoor recording (halogen lamp, etc.)
P5600K
(P5600K)
Preset value for outdoors
VAR (VAR)
Setting can be finely adjusted in accordance to the recording conditions.
(l 63)
Ach (Ach)
Setting can be optimized for the scene to be recorded when you press the
WHITE BAL button to switch to [Ach]. (l 63)
Bch (Bch)
Setting can be optimized for the scene to be recorded when you press the
WHITE BAL button to switch to [Bch]. (l 63)
AG-UX90EJ_DVQP1150ZA.book 61 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分
To Next Page
Loading...
