Panasonic AJ-D230H - Page 100

3-25
(Adjustment)
1. Install the MIC Geneva Gear to the Chassis.
2. Place the Reels in the M-Size position by hand.
3. Install the MIC Drive Arm Unit.
4. Place the REC Inhibit SW in front position on
Distinction SW Unit by rotation of MIC Geneva
Gear, and then MIC Geneva Gear should be
positioned as shown in Figure 1-29-3.
Note:
Protrusion of MIC DRIVE Arm Unit is positioned as
shown in Figure 1-29-3.
Figure 1-29-3
5. Install the Reel Drive Cam Gear and hole of Reel
Drive Cam Gear should be matched with the hole
of MIC Geneva Gear as shown in Figure 1-29-3.
6. Install the Cut Washer (A), (B) and (C) as shown
in Figure 1-29-1.
Point of Adjustment:
1) Reel in M-Size position.
2) Set the REC Inhibit SW in front position of
Distinction SW Unit.
3) Protrusion of MIC Drive Arm Unit is positioned as
shown in Figure 1-29-3.
4) Holes between Reel Drive Cam Gear and MIC
Geneva Gear are matched.
1-30. M-Stopper Solenoid
Replacement & Adjustment
(except Camera Recorder)
<CHART B>
Model Type TYPE A TYPE B
Connector (A) P24 P2024
P.C.Board (B) MECH I/F SERVO
(Removal)
1. Remove the connector (A) on the P.C.Board
(B).
2. Unscrew the 4 screws (A) and (B) and remove
the M-Stopper Solenoid as shown in Figure 1-30-
1.
(Installation)
1. Install the new M-Stopper Solenoid follow the
removal steps in reverse order.
2. After installation, position adjustment should be
performed as follows.
Figure 1-30-1
REEL IN M POSITION
HOLE
DISTINCTION
SW U.
DISTINCTION SW U.
IS PLACED
FRONT POSITION
MIC RAIL U.
MIC DRIVE
ARM U.
PROTRUSION OF MIC DRIVE ARM U.
SHOULD BE LOCATED AS FIGRE
REEL DRIVE
CAM GEAR
MIC GENEVA
GEAR