Panasonic AJ-D230H - FF, REW Mode Tape Pass Limit Confirmation; REV Mode Tape Pass Limit Confirmation; Screw Lock Tight of A;C Head and T3, T4 Post

2-36
3-25. REV mode Tape Pass Limit
Confirmation
SPEC Each post limit shown in below figure
MODE REV
TAPE
NTSC : VFM3580KM or VFM3580KL
PAL : VFM3680KM or VFM3680KL
Post Name Tape Limit (Refer to figure 3-25)
A B C D E F
S5 Post OK OK OK NG NG NG
S4 Post
(Tension Post)
NG OK OK NG NG NG
S1 Post OK NG NG NG NG NG
T1 Post OK OK OK NG NG NG
T3 Post NG NG OK NG NG NG
T4 Post OK OK OK NG NG NG
1. Place unit into REV mode and confirm the each
post limits is within specification.
2. If out of specification, adjust the post height follow
the each adjustment procedure (Refer to Table 3-
22 on item 3-22)
Figure 3-25
3-26. FF, REW mode Tape Pass
Limit Confirmation
SPEC Each post limit shown in below figure
MODE FF, REW
TAPE
NTSC : VFM3580KM or VFM3580KL
PAL : VFM3680KM or VFM3680KL
Post Name Tape Limit (Refer to figure 3-25)
A B C D E F
S5 Post OK OK OK NG NG NG
S4 Post
(Tension Post)
NG OK OK NG NG NG
S1 Post OK NG NG NG NG NG
T1 Post OK OK OK NG NG NG
T3 Post OK OK OK NG NG NG
T4 Post OK OK OK NG NG NG
1. Place unit into FF and REW mode and confirm the
each post limits is within specification.
2. If out of specification, adjust the post height follow
the each adjustment procedure (Refer to Table 3-
22 on item 3-22)
3-27. Screw Lock Tight of A/C Head
and T3, T4 Post
<Screw Lock Tight of A/C Head>
SCREW A OTHER
SCREWS
Lock Tight Grew
Quantity
1/3 of the
screw
1/3 of the
screw
1. Fix the screw by the Lock Tight Grew after A/C
Head Adjustment as shown in below figure.
2. Melt the grew before adjust each screws.
<Screw Lock Tight of T3 and T4 Post>
SCREW A OTHER
SCREWS
Lock Tight Grew
Quantity
1/4 of the
screw
1/4 of the
screw
1. Fix the Nut by the Lock Tight Grew after T4 Post
Height Adjustment.
2. Melt the grew before perform adjustment.
A:
B: FREE
C: LOWER
D: CURL
E: BEND
F: DROP