3-1
1. Major Mechanical Parts Replacement & Adjustment Procedures
GENERAL
This procedure is mentioned some name of
P.C.Board and connector number. The name of
P.C.Board and number of connector are difference
each DVCPRO VTR and CAM CODER. Therefore
each models classified 4 types as indicated as below
table <CHART A>. If the item (1-1 to 1-31) have table
<CHART B>, the model No. is discriminated by
<CHART A>.
With item of “1-6.Confirmation of Main Brake
Torque”, is described two difference specification.
Please select the specification follow the <CHART
C>.
<CHART A>
TYPE A AJ-D440, AJ-D450, AJ-D640,
AJ-D650, AJ-D750, AJ-D780,
AJ-D850, AJ-D940, AJ-DE77,
AJ-D950, AJ-D950A,
TYPE B AJ-D220, AJ-D230, AJ-D230H,
AJ-D250, AJ-LT75, AJ-LT85,
AJ-D95DC, AJ-D92, AJ-D94,
TYPE C AJ-D400, AJ-D700, AJ-D700A,
AJ-D800, AJ-D800A, AJ-D810,
AJ-D810A, AJ-D90, AJ-D900W,
AJ-PD900W, AJ-D900WA,
AJ-PD900WA, AJ-D910WA,
AJ-D610,
TYPE D AJ-D200, AJ-D210, AJ-D215
When mechanical parts are replaced, pay attention to
the following notes.
1. Always turn power off before replacing any parts.
2. If any adjustment is required replacing parts,
perform the required adjustment.
3. Use proper hard tools of fixtures.
4. Be sure to clean the parts after replacement, also
when the mechanical parts are replaced, follow
the replacement procedure.
1-1. Cylinder Unit Replacement
<CHART B>
Model Type TYPE A TYPE
B
TYPE
C,D
Connector (A) P33 P2033 P613
P.C.Board (B) MECH
I/F
SERVO SERVO
To Next Page
Loading...
