Panasonic AJ-D230H - Set-up Menu: MEMORY and TAPE PROTECT Options; Memory Operation Modes; Tape Protection Settings

2-11
2-9. AJ-D940
<Table of Test Point>
Name AJ-D940
[ Tension Arm Adjustment ]
TENSION SERVO (F1) : TP201
TENSION OFFSET MECHA I/F : VR1
TENSION GAIN MECHA I/F : VR2
[ Photo Sensor Voltage Adjustment ]
S-side Output SYSCON (F2) : P2 – 25PIN
T-side Output SYSCON (F2) : P2 – 26PIN
Adjustment Point MECHA I/F : SW200
[ Tape Pass, A/C Head Adjustment ]
PB-ENV L13 RF (H3) : TP17
PB-ENV L24 RF (H3) : TP19
PB-ENV R13 RF (H4) : TP17
PB-ENV R24 RF (H4) : TP19
DV-ENV L12 RF (H2) : TP17
DV-ENV R12 RF (H2) : TP19
TSR SERVO (F1) : TP300
FP-S0 (FRAME PULSE) SERVO (F1) : TP301
PB-HSW L13 SERVO (F1) : TP722
PB-HSW L24 SERVO (F1) : TP723
PB-HSW R13 SERVO (F1) : TP724
PB-HSW R24 SERVO (F1) : TP725
DV-HSW L12 SERVO (F1) : TP902
DV-HSW R12 SERVO (F1) : TP901
LIVE-CTL SERVO (F1) : TP30
CUE CUE (H1) : TP101
[ LISTA Adjustment ]
ATF ERR L SERVO (F1) : TP732
ATF ERR R SERVO (F1) : TP734
TRG PB-HSW L13 SERVO (F1) : TP722
DV-HSW R12 SERVO (F1) : TP901
GND SERVO (F1) : TG510
ATF GAIN Select the EVR on the Service Menu.
(Refer to below table <LISTA Adjustment Mode>)
<A/C Head Adjustment Mode>
Adjustment Name
Format Select
Adjustment Mode (Select on the Service Menu)
Azimuth, X Value Adj. 50M Select the item “A05 : PBL13 LINEAR”
<LISTA Adjustment Mode>
Adjustment Mode
Format Select Connection Point
Adjustment Name (LISTA Software) Service Menu Item ATF ERR TRG
Sens. Adj. (DVL Head) “A10 : DVL GAIN” DV-HSW L12
Linearity Adjustment “A11 : DVL LINEAR” ATF ERR L
Sens. Adj. (PBL Head) 50M mode “A04 : PBL13 GAIN” PB-HSW L13
Sens. Adj. (PBR Head) “A08 : PBR13 GAIN” ATF ERR R PB-HSW R13
Sens. Adj. (DVR Head) “A12 : DVR GAIN” DV-HSW R12
<CTL Control Mode>
Adjustment Name
Format Select
Adjustment Mode (Select on the Service Menu)
ENV Waveform Confirmation
25M
(CTL control)
“A14 : ENV SEL 25M”
“A15 : TRK VAL 25M”