3-26
(Adjustment)
1. Place the reels in the L size position.
2. Push the iron core of M-Stopper Solenoid by
hand.
3. Observe the clearance (A) between Mech.
Chassis and M-Stopper as shown in Figure 1-31-
2. And make sure that it is within 1.1 to 1.3mm.
4. If not, loosen the 2 screws (A), which fixed M-
Stopper Solenoid. And adjust the position of M-
Stopper Solenoid so that the clearance (A) is
within specification. And tighten the 2 screws (A).
Figure 1-30-2
1-31. T4 Post Position Adjustment
1. Confirm that the hole (B) of T4 connection Gear
was matched to hole of T4 post as shown in
figure 1-31.
2. Confirm that the portion (C) of T4 connection
Gear and hole (A) , which are located as shown
in figure 1-31.
3. If not, adjust the phase of T4 post follow the
above procedure.
Note:
This confirmation should be performed on unloading
condition.
Figure 1-31
To Next Page
Loading...
