3-9
Figure 1-8-2
1-9. Take-up Brake Solenoid
Replacement and Adjustment
(except Camera Recorder)
<CHART B>
Model Type TYPE A TYPE B
Connector (A) P15 P2015
P.C.Board (B) MECH I/F SERVO
(Removal)
1. Disconnect the connector (A) on the P.C.Board
(B). (Refer to above chart.)
2. Unscrew the 2 screws (A) and remove the Take
Up Brake Solenoid Base Unit as shown in Figure
1-9.
3. Unscrew the 2 screws (B) and remove the Take
Up Brake Solenoid from Take Up Brake Solenoid
Base Unit as shown in Figure 1-9.
Figure 1-9
(Installation)
1. Install the new Take up Brake Solenoid follow the
removal steps in reverse order.
Note:
Hang on the Take up Brake Spring as shown in
Figure 1-9.
2. After installation, position adjustment should be
performed as follows.
(Adjustment Procedures)
1. Please adjust the position of Take up Brake
Solenoid Unit follow the adjustment procedure,
which is described item “1-8. Supply Brake
Solenoid Replacement and Adjustment”.
To Next Page
Loading...
