3-17
Figure 1-20-2
Figure 1-20-3
(2) Checking for smooth movement of T1 Boat Unit.
Check X-Value. Check for smooth loading and
unloading operations. If not smooth (especially,
at curve of rail), take the following steps.
1. Check T1 boat joint for deformation.
2. If no deformation, then reposition the loading
rail as describe below.
Figure 1-20-4
1. Loosen the screw A.
2. While pressing the projection B leftward,
tighten the screw.
If operation is not smooth, remove CYL and
loosen screws A and C. Turn the rail clockwise as
shown in the figure and then tighten the screws.
If the rail does not work well, replace it or the T1
boat with a new one.
To Next Page
Loading...
