3-19
1-23. A/C head Replacement
& Adjustment
<Tools required>
Nut Driver (5.5mm : VFK1150)
Hex Driver (VFK1148)
Hex Wrench (VFK1190)
<CHART B>
Model Type TYPE A TYPE B
Connector (A) P4002 P4502
P.C.Board (B) CUE AUDIO
Connector (C) P4003 P2030
P.C.Board (D) CUE SERVO
Model Type TYPE C TYPE D
Connector (A) P600 P600
P.C.Board (B) SERVO SERVO
Connector (C) P1003 P1005
P.C.Board (D) REAR JACK REAR JACK
(Removal)
1. Loosen the hex screw (B) and remove the Nut
(C). Hang off the Head Height Adjustment Spring
and then remove the A/C Head Unit as shown in
Figure 1-23-1.
Point:
Memorized height of the Nut (C) before remove the
Nut (C).
Figure 1-23-1
3. Remove the 2 screws (A) and disconnect the
connector (A) on the P.C.Board (B) and
connector (C) on the P.C.Board (D), and then
remove the A/C Head from the A/C Head Plate
as shown in Figure 1-23-2.
Figure 1-23-2
4. Remove the Shield Cover by removing 2 screws
(D).
5. Unsolder the lead wires as shown in Figure 1-23-
3. (When unsolder the lead wires, do not
unsolder all at the same time)
To Next Page
Loading...
