Operating Instructions
107
Note
• If your camera will only be accessed on your local network, use each
camera's local IP address and port number.
• If you intend to access your camera from the Internet, you must use each
camera's host name (global IP address) and the port number.
4. Click [Save] when finished.
• The new settings are saved.
• The Multi-Camera Setup page is displayed.
Setting Description
Display • Check this box to enable the camera.
IP Address
*1
or
Host Name
*2
• Set an IP address or host name to enable the camera.
Port No. • Set a port number (1—65535).
Camera Name
*3
• This camera name is displayed only on the Multi-Camera
page.
*1
Set 4 numbers (0—255) and 3 periods, such as "192.168.0.253". Note that
"0.0.0.0" and "255.255.255.255" are not available.
*2
Enter ASCII characters for the host name (see page 145). Note that [Space],
["], ['], [#], [&], [%], [=], [+], [?], [<] and [>] are not available.
Enter 1—255 characters.
*3
You can enter ASCII characters (see page 145) or characters from other
languages (1—15 characters for a 1-byte character and 1—7 characters for a
2-byte character). Note that [Space], ["], ['], [#], [&], [%], [=], [+], [?], [:], [<], and
[>] are not available.
To Next Page
Loading...
Need help?
General
