Operating Instructions
54
3. Click [Save] when finished.
• The new settings are saved.
• When finished, "Success!" is displayed.
4. Click [Go to UPnP page].
• The UPnP page is displayed.
2.4.1 Connecting the Camera to a Router that Supports
UPnP™
To allow access from the Internet with a router supporting UPnP
TM
, follow the
procedures shown in Getting Started.
Note
• On some routers, the UPnP
TM
feature is disabled by default. Enable your
router's UPnP
TM
feature following the router manual before you set up the
camera. See the Panasonic Network Camera support website at
http://
panasonic.co.jp/pcc/products/en/netwkcam/ for details.
• If a maximum idle time is set in PPPoE or PPTP connection with your ISP,
disable it on the router. See the router manual for details.
To Next Page
Loading...
Need help?
General
