Operating Instructions
106
5.2 Configuring Multiple Cameras
The Multi-Camera Setup page allows you to configure camera IP addresses and
camera names to view multiple images on the Multi-Camera page. These
configurations are required to use the Multi-Camera page. Up to 12 cameras can
be configured. The Selfcamera is registered at No. 1 by default.
1. Click [Multi-Camera] on the Setup page.
2. Click Add.
Note
• If you click the camera number, the modification page is displayed.
Camera settings can be modified or deleted here.
• If you configured multiple cameras, you can change the camera number.
Select the number, and click [Move].
3. Set each parameter.
• Clicking [Cancel] cancels your settings without saving changes.
• By clicking [Clicking this link, enters this camera's settings.], the settings
of the Selfcamera are entered automatically. "selfcamera" is displayed for
the IP Address or Host Name, "--" is displayed for the Port No., and the
model no. is displayed for the Camera Name.
To Next Page
Loading...
