Operating Instructions
84
4.3 Buffering or Transferring Images by Motion
Detection Signal
The Trigger page allows you to enable image buffer/transfer by E-mail or FTP.
Note
• The level of motion detection depends on resolution, image quality, and
the object being viewed. Check the level by performing motion detection
recording. (See page 97)
• Enabling Motion Detection delays the frame rate of the camera.
• A change to light or wind conditions may detect motions accidentally.
• Motion Detection may not work in dark areas.
• Objects moving fast may not be detected.
1. Click [Trigger] on the Setup page.
2. Click a No. to enable buffer/transfer.
3. Check [Enable Image Buffer/Transfer], select [Motion Detection] for the trigger,
and click [Next>].
To Next Page
Loading...
