Operating Instructions
19
Camera Feature Locations
Front View
Indicator Display
*1
*
1
The information below varies depending on the indicator settings (see page 110).
*
2
The indicator turns orange if the camera is not connected to the LAN.
*
3
The indicator blinks orange if the camera is not connected to the LAN.
*
4
See page 4 of Troubleshooting on the CD-ROM.
Antenna
FACTORY DEFAULT
RESET Button
Indicator
The indicator color
shows camera status.
Lens
(0.3 m—Unlimited)
Power
on
Normal Operation*
2
Updating Firmware
Getting IP address*
3
Got IP address
Setting
Finished setting
Not on LAN
Orange blinking
Orange blinking
(The camera is reset to factory default status after 1 minute.)
FACTORY DEFAULT RESET
button pressed
Orange blinking Turning off (about 5 seconds)
UPnP
TM
Failure Orange blinking (About a 2-second interval)
On LAN
Using
DHCP
Automatic
Setup
Internal Failure Red blinking*
4
Green
Green
Green
Green blinking
Green blinking
Orange
Orange
Orange blinking GreenGreen blinking
Orange blinking
The status when turned on
To Next Page
Loading...
