Operating Instructions
46
4. Click [Save] when finished.
• The new settings are saved.
• When finished, the following page is displayed.
Note
The current network settings are shown on the Status page in the Maintenance
section (see page
112).
5. Click [Restart].
• The camera restarts, and the Top page is displayed.
• When the camera is restarted, all buffered images in the internal memory
are deleted.
• Checking [Yes] for [Allow Access from the Internet] on [Automatic Setup]
may not display the Top page, since the port number may change. Use the
Setup Program to access the camera.
DHCP Setup Static Setup
• Clicking [Cancel] takes you back to the previous page without
saving changes.
To Next Page
Loading...
Need help?
General
