Panasonic BL-C20

Operating Instructions
82
How to
authenticate
You can select the authentication method: [No authentication],
[POP before SMTP authentication] and [SMTP authentication].
POP server authentication may be required by your ISP. In
that case, set POP before SMTP authentication.
• No authentication: No authentication when sending an e-
mail.
• POP before SMTP authentication: Some SMTP servers
that send e-mails do not have an authentication feature.
Therefore, the camera uses the authentication of a POP
server that receives e-mails, before sending e-mails.
– POP3 Server
IP Address or
Host Name
*1
:
If you set a server IP address, set 4
numbers (0—255) and 3 periods, such as
"192.168.0.253". Note that "0.0.0.0" and
"255.255.255.255" are not available. Or
set a host name (1—255 characters).
– Port No.: Enter a number (1—65535). Usually set
to 110.
– Login ID
*2
: If your ISP requires a login ID to log in to
a POP3 server, set it (1—63 characters).
– Password
*2
: If your ISP requires a password to log in
to a POP3 server, set it (0—63
characters).
• SMTP authentication: Users are authenticated by user
name and password on the SMTP server. Your ISP must
support the SMTP authentication. Only the LOGIN and
PLAIN authentication mechanisms are supported.
– Login ID
*2
: If your ISP requires a login ID to log in to
an SMTP server, set it (1—63
characters).
– Password
*2
: If your ISP requires a password to log in
to an SMTP server, set it (0—63
characters).
*1
Note that [Space], ["], ['], [&], [<] and [>] are not available.
*2
Note that ["] is not available.
Setting Description