Operating Instructions
96
10. Click [Go to Trigger page].
• The Trigger page is displayed.
Note
• If you set a short interval when transferring to a mobile phone, many E-
mails will be sent, which may lead to a large phone bill. Therefore, we
recommend you to set a long interval. 1 image per minute frequency is
recommended.
• Motion Detection transfer stops operating until after the camera finishes
all transfers. For example, if the camera transfers 3 images per minute and
6 images in total by setting 1 minute for motion deactivation time, the
sensor will follow the pattern below.
• If you are buffering images to the internal memory, the following
operations also delete all buffered images.
– Turning off the camera.
– Saving the Date and Time page.
– Restarting, updating firmware or resetting the camera to factory
default.
Detectable Undetectable
Detectable
Motion
deactivation time
Undetectable
1st 2nd 3rd 4th 5th 6th
120 seconds
1 minute
A Motion Detection signal is detected.
To Next Page
Loading...
Need help?
General
