EasyManua.ls Logo

Panasonic Bread Bakery SD-253 - Replacement Parts; Specifications

Panasonic Bread Bakery SD-253
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Reason/Cause
Condition
Motor protection device
Remedy 2
There has been a 10-minute or
less power cut. (The power plug
has been inadvertently pulled out or
the breaker has activated.)
Or there has been a slight change in
the power supplied to the machine.
How to reset/restart
If the interruption in the power supply is
momentary, the operation will not be affected.
Not baked at all, although
the operation appears to
have proceeded.
Check to see if the kneader mounting shaft can
rotate.
Motor protection device has activated.
This only happens when the unit is
overloaded and an excessive force
is applied to the motor.
After about 30 minutes, the motor
automatically starts running again.
If the unit is overloaded and an excessive force is applied to the motor, the protection device will
stop the motor. After approximately 30 minutes, the motor will automatically start running again. It is
recommended to restart with fresh ingredients.
If the kneading blade is restricted by hard dough, take out the dough. The
unit will restart 30 minutes later.
Check to see if the kneader mounting shaft of the bread pan can rotate.
If it can rotate, restart the bread maker after 30 minutes. If it cannot rotate,
service will be required.
Make sure you did not use
too much or too hard/heavy
ingredients, then start again
using all new ingredients.
Service will
be required.
is on
display.
appears
on
display.
is on
display.
There has been a power cut for a
certain period of time. (The length of
time may differ according to the
circumstances.) (Possible causes:
power failure, unplugging of the power
cord, or a malfunctioning of household
fuse or breaker).
Leave the unit as it is.
When the unit has cooled to below 40ûC/105ûF,
will disappear from the display window
and the flashing red operation light will go out.
This indicates that the unit is now ready to use.
The unit is hot (above 40ûC/105ûF).
This may occur during repetitive use.
You must allow the unit to cool down
before reusing.
TEMP
TEMP
POWER ALERT
Yes
No
Remedy 1
Remove the dough and start again using all
new ingredients.
If the power is restored within 10 minutes,
the bread maker will operate again.
However, the bread may not turn out well.
Display Indications for Abnormal Conditions
45

Table of Contents

Other manuals for Panasonic Bread Bakery SD-253

Related product manuals