73
14.10 Info Function
Purpose
o To check the energy charging level.
o To check the diagnosis code for malfunction.
To check the energy charging level.
o Air conditioner must be operate in heating mode.
o Press Info
INFO
button on the remote controller to check energy charging level.
o Display will be indicate of the storage of heat that can be used in the non-stop defrost operation.
o Energy charging level (0~4).
o Energy charging level will be displayed on the remote controller display for 4 seconds then it will return to the
original display.
o When press the info button in any operation except heating, remote control will display as “__”.
To check the diagnosis code for malfunction.
o Once abnormality has occurred during operation, the unit will stop its operation and Timer LED blinks.
o Press Info
INFO
button on the remote controller to check diagnosis code.
“beep, beep, beep, beep” sound can be heard and display "diagnosis" then show alphanumeric (H□□ or F□□).
Diagnosis code will be displayed on the remote controller display for 4 seconds then it will return to the original
display.
14.11 Indication Panel
LED POWER TIMER +8/10ºC nanoe/ODOR CLEANUP ECONAVI
Color Green Orange Green Blue Green
Light ON Operation ON Timer Setting ON +8/10ºC HEAT ON
nanoe /
ODOR CLEANUP ON
ECONAVI ON
Light OFF Operation OFF Timer Setting OFF +8/10ºC HEAT OFF
nanoe /
ODOR CLEANUP OFF
ECONAVI OFF
Note:
If Operating LED is blinking, the possible operation of the unit are HOT Start, during Deice operation, operation
mode judgement, or ON timer sampling.
If Timer LED is blinking, there is an abnormality operation occurs.
To Next Page
Loading...
