Panasonic CS-VZ9SKE - Remote Control Button

96
 Individual Mode
"Beep"
Existence of abnormality detection
Emergency SW
Non-existence of notification sound
"Beep"
"Beep"
Existence of receive sound
Emergency SW
Existence of receive sound
"Beep"
"Beep"
Existence of notification sound
Emergency SW
Non-existence of notification sound
"Beep"
Notification sound ON/OFF
Set mode
Diagnosis code received
"Beep"
Indoor intake sensor abnormality (H14)
Notification selection mode
Diagnosis code received
"Two Beep"
Smart consumer electronics operation
Receive sound selection mode
Diagnosis code received
"Three Beep"
Not used
Diagnosis code received
"Four Beep"
Not used
Diagnosis code received
"Bleep"
 Each mode is cancelled if no operation is performed for 5 minutes or any code other than the
diagnosis code is received from the remote control.
16.2 Remote Control Button
16.2.1 RESET
 To reset the remote control.
o Press once to restore the unit setting.