Panasonic CU-MVG153KE - Remote Control

12.3. REMOTE CONTROL
12.3.1. Remote Control reset
When the batteries are inserted for the first time, or the batteries are
replaced, all the indications will blink and the remote control might not
work.
If this happens, remove the back cover of the remote control and you
will find a resetting terminal, and by shorting it with a minus screwdriver,
it will return to normal.
12.3.2. Changing the wireless remote control transmission code
By adding a jumper wire to the remote control side, it is possible to select 4 transmission codes including one at time of delivery
condition (1).
Remote control Indoor Setting Code Note
Switch SW B
←→
A J-1
1 A --- A At product delivery
2 B --- B
3 A Jumper wire C
4 B Jumper wire D
12.3.3. Remote Control Batteries
The batteries can be used for approximately one year. When the
batteries become weak, the display of the remote control may fade or
disappear. Replace the batteries immediately.
60
CS-MVG103KE / CU-MVG153KE