7-15
7
(Continued from previous page)
Item code Item Description
3C
Heat exchanger
temperature for cold air
discharge
The heat exchanger temperature control point for prevention of cold
air discharge during heating operation can be changed.
3d
Fan output switching
The indoor unit PCB optional output for the fan can be switched
according to the purpose of use.
3E
Drain pump delayed start
time
The drain pump starts after the set time delay after cooling operation
stops.
40
Humidifier drain pump
setting
This specifies the humidifier and drain pump setting.
45
DC flap operation mode Changes flap operation to draft reduction mode.
46
DC flap swing mode Selects the swing operation mode for the flap.
5d
DC fan tap setting
Sets the DC fan tap according to the purpose of use.
Change the settings data at the same time.
5E
Humidifier ON time
Sets the humidifier output ON time for when the humidifier is
operating.
ON/OFF control is performed during humidifier operation.
This setting therefore sets the ON time per 60-second interval.
5F
Stop at time set for OFF
timer after operation starts
This setting enables a function that stops operation when the
amount of time set for the OFF timer has passed after remote
controller operation was started.
60
Timer function change
prohibit
This function prohibits changes from being made to the remote
controller time setting.
62
Smudging control Smudging control is disabled when 0000 is set.
Sec7.inddīīī13 2012/02/28īīī15:07:26
SM830231-02īSingleī꬧å·.indbīīī15SM830231-02īSingleī꬧å·.indbīīī15 2014/09/09īīī21:19:302014/09/09īīī21:19:30
To Next Page
Loading...
Need help?
General
