Panasonic DP-C405 - Page 339

339
DP-C405/C305/C265
FEB 2008Ver. 1.1
E5: System Error Codes
Code Function Contents Section Check Points
E5-01 Vp
(+24V, Printer)
Interlock Switch
failure (+24V).
Interlock
Switch
1. LVPS (+24V) Output is abnormal.
2. Check the EC PCB (+24V) connector
(CN519).
3. EC PCB is defective. (Check F1&F14)
E5-02 Vp
(+12V, Printer)
Interlock Switch
failure (+24V).
Interlock
Switch
1. LVPS (+24V) Output is abnormal.
2. Check the EC PCB (+24V) connector
(CN519).
3. EC PCB is defective. (IC 25 is defective)
(Check F14)
E5-05 Vp
(+24V, Scanner)
No LVPS (+24V) to
SCN PCB Voltage
detected.
LVPS 1. Check the SCN PCB connector (CN709).
2. SCN PCB is defective.
3. Check the LVPS connector (CN702).
4. LVPS is defective.
E5-10 Sequence Error Sequence is not
completed within a
predetermined time.
EC PCB 1. Incorrect EC ROM Version.
2. Check the EC PCB connector.
3. EC PCB is defective.
E5-11 Printer Engine
Communication
Abnormal
Communication Error
occurred between
SC, CONE, and EC
PCBs.
CONE PCB 1. Check the EC PCB connector (CN501).
2. EC PCB is defective.
3. Check the SC PCB connector (CN61).
4. SC PCB is defective.
5. CONE PCB is defective.
E5-12 Scanner Engine
Communication
Abnormal
Communication Error
occurred between
SCN and SC PCBs.
SCN/SC
PCB
1. Check the SCN PCB connector (CN709).
2. SCN PCB is defective.
3. Check the SC PCB connector (CN53).
4. SC PCB is defective.
E5-13 Printer Engine
Communication
Abnormal
During
Initialization
Communication Error
occurred between
SC, CONE and EC
PCBs.
CONE PCB 1. Check the EC PCB connector (CN501).
2. EC PCB is defective.
3. Check the SC PCB connector (CN61).
4. SC PCB is defective.
5. CONE PCB is defective.
E5-17 Scanner
Synchronization
Communication Error
occurred between
SCN and SC PCBs.
SCN/SC
PCB
1. Check the SCN PCB connector (CN709).
2. SCN PCB is defective.
3. Check the SC PCB connector (CN51).
4. SC PCB is defective.
E5-19 Scanner Line
Synchronization
Communication Error
occurred between
SCN and SC PCBs.
SCN/SC
PCB
E5-22 Finisher
Communication
Abnormal
Communication Error
occurred between
Finisher and Host
Machine.
Finisher 1. Check the EC PCB connection.
2. EC PCB is defective.
3. Check the IPC PCB connection.
4. IPC PCB is defective.
5. Check the Finisher Interface Cable
connection.
6. Check the OP LVPS connector.
7. OP LVPS is defective.
8. Check the DC PCB connection.
9. Finisher is defective.