Panasonic DP-C405

64
FEB 2008Ver. 1.1
DP-C405/C305/C265
2.5. Resetting the P/M (Preventive Maintenance) Counter
When the machine reaches the preset P/M Cycle, it will show “Call for P/M” on the LCD Display. The PM
Counter can be reset by following the procedures below.
1. Perform the P/M (Preventive Maintenance), refer to sections 2.3. and 2.4.
2. Press the “Function”, “Copy”, and the “3” keys simultaneously on the Control Panel.
3. Input the password, and select the “OK” button to enter the Service Mode (default password is
00000000, except for DP-C322 Series).
4. Press the “8” key on the Control Panel, and then press the “Start” key to enter the F8 Service Mode.
(Service Adjustment).
5. Reset the desired Counter(s) on the list below.
6. Press the “Stop” key first on the Control Panel, and then press the “Function”, and the “C (Clear)”
keys simultaneously to return to standby.
No. Mechanical Parts
Ref.
No.
Replace
Ref.
Counter
Replace
Alarm
Reset
Counter
Cycle
(Sheets)
i-ADF Unit
1 Pickup Roller 511 240K
F7-02-12
ADF Count
PM
Display
(Machine
Continues
Operating)
Enter the Copy Service Mode F5-
87 (ADF PM Cycle), and change to
the desired value.
2 Paper Feed Roller 508 240K
3 Separation Roller 610 240K
Fuser Unit
9 Fuser Belt Unit 4926 120K
F7-02-65
Fuser Belt
Remain
Count
(Count
Down)
119K:
Alarm
121k:
Machine
Stops
Perform “F8-26 Fuser Belt Counter
Reset”.
(F7-02-65 Fuser Belt Remain
Count is also initialized by this
operation)
10 Fuser Main Unit 4927 240K
F7-02-66
Fuser Main
Remain
Count
(Count
Down)
239K:
Alarm
241K:
Machine
Stops
Perform “F8-27 Fuser Main
Counter Reset”.
(F7-02-66 Fuser Main Remain
Count is also initialized by this
operation)
-
Complete Fuser Unit
(Fuser Belt Unit, and
Fuser Main Unit)
4815 - - -
Perform “F8-26 Fuser Belt Counter
Reset”, and “F8-27 Fuser Main
Counter Reset”.
(F7-02-65 Fuser Belt Remain
Count, and F7-02-66 Fuser Main
Remain Count are also initialized
by this operation)
Intermediate Transfer Unit
11
Intermediate
Transfer (IT) Belt
3419 240K
F7-02-51
Belt Life
Count
Down
239K:
Alarm
241K:
Machine
Stops
Perform “F8-29 Belt Counter
Reset”.
(F7-02-51 Belt Life Count Down is
also initialized by this operation)
Perform “F8-30 Color Reg”.
12
First Transfer Roller
(FTR)
3546 240K
13
Drive Roller Brush
Assembly
3635 240K