Panasonic DP-C405

351
DP-C405/C305/C265
FEB 2008Ver. 1.1
3.6. Information Codes Table (For Facsimile)
Fax Information Codes
Code Mode Phase Description of Problem Cause
012 RCV C, D The length of the received
document is over 2 m.
Transmitter Document Jam.
030 XMT B Read Point Sensor does not
activate within 10 seconds after the
document starts feeding.
Document is not set properly.
Defective Read Point Sensor.
031 XMT
COPY
C Transmitting document was longer
than 2,000 mm (or 78.7 in).
(Super Fine / 600 dpi: 1,387 mm
(or 54 in))
The document may jam.
Defective Read Point Sensor.
061 - A ADF Door is open. Cover is not firmly closed.
Connectors are not firmly connected.
212 XMT
RCV
A-E Interface error occurred between
the CPU and modem.
Modem is defective. (FCB PCB)
Software problem occurred. (SC PCB)
The line is defective.
400 XMT B T1 timer (35±5 sec) elapsed
without detecting 300 bps signal.
Wrong number is dialed and the START
button is pushed.
Telephone line is disconnected while
dialing.
FCB PCB (Modem) is defective.
Receiver is defective. (It may only be
transmitting CED)
401 XMT B DCN was returned from receiver
while transmitter is waiting for CFR
or FTT.
Your machine's ID Number is not
programmed.
Possible incompatibility, or incorrect
Password (Password Reception,
Selective Receive).
Mailbox is full.
402 XMT B DCN was returned from receiver
while transmitter is waiting for NSF/
DIS.
Receiver working in non-CCITT mode
only. (Possible incompatibility)
403 RCV
(Polling)
B Transmitter had no polling function. "POLLED=ON" (polling XMT ready) is
not set at the transmitter.
Document to be transmitted is not
placed at the transmitter.
404 XMT B Transmitter sent NSS (or DCS)
followed by TCF three times, but
the receiver did not respond. (CFR
or FTT is usually returned)
Receiver is defective. (Modem, etc.)
FCB PCB is defective.
Receiver disconnects line during first
NSS (or DCS) is transmitted.
405 XMT B Transmitter received FTT after it
transmitted TCF at 2400 bps.
Received RTN after communicating
at 2400 bps.
Line quality is poor. (TCF is damaged
due to line noise)
Receiver is defective. (Modem, etc.)
FCB PCB is defective.
406 RCV
(Password
Comm.)
B XMT-Password mismatched. RCV-
Password mismatched.
Selective RCV incomplete.
XMT, RCV password does not match.
Last 4 digits of TSI does not match with
the last 4 digits of Auto Dial telephone
number.