82
FEB 2008Ver. 1.1
DP-C405/C305/C265
2.10. Power on Display Change (F9-19)
To change the startup Panel Display (when the Power Switch on the Left Side is turned ON) follow the
procedure below. This feature is useful if a Dealer wants to personalize the machine with its own company's
Logo or Picture (New feature for DP-C405 Series).
<Prepare>
1. Save your selected JPEG image file onto the designated folder in the SD Memory Card using a
designated file name.
Designated Folder : \private\meigroup\pcc\di\image\ (Default folder for Scan to SD Card)
Designated File : image.jpg (Default file name for Scan to SD Card)
Designated File type : JPEG
<Procedure>
1. Install the SD Memory Card into the Front SD Card Slot.
2. Select the Service Parameter “F9-19 Power On Display”, then select “Custom” and “OK”.
3. Select “OK” to register the image.
Note:
1. Use an appropriate sized (640 x 480 pixels) image data to fit into the Display Panel without cropping or
cutting off.
Example: If the image size is A4 the display will have borders filled in Light Blue.
2. The image file for Custom setting is saved in the F-ROM on the SC PCB.
3. When the SC firmware is updated or RAM Initialize (Shipment Set, Parameter Initialize) is executed,
the Custom image file is deleted, and the display returns to the Original default screen setting.
To Next Page
Loading...
