Panasonic DP-C405 - Page 341

341
DP-C405/C305/C265
FEB 2008Ver. 1.1
E7: Optional Unit Error Codes
Code Function Contents Section Check Points Unit
E7-21 Finisher
Paper Exit
Motor
Finisher Paper Exit
Motor is jammed.
Finisher 1. Check the Paper Feed Motor
connector.
2. Paper Feed Motor is paper jammed.
DA-
FS405/
FS356/
FS325
only
E7-23 Finisher
Staple Motor
Finisher Staple
Home Position
Sensor does not
turn Off/On within a
predetermined time.
Finisher 1. Check the Stapler Unit connector.
2. Stapler Unit is defective.
3. Stapler Home Position Sensor is
defective.
4. Stapler Cover Micro-SW is defective.
5. Saddle Unit Micro-SW is defective.
6. Check the Large Solenoid Gear
connector.
7. Large Solenoid Gear is defective.
8. Check the Paper Feed Motor
connector.
9. Staple Motor is jammed with a staple.
DA-
FS405/
FS402/
FS356/
FS325/
FS350/
FS320
E7-24 Finisher
Staple Shift
Motor
Finisher Staple Shift
Home Position
Sensor does not
turn Off/On within a
predetermined time.
Finisher 1. Check the Staple Shift Motor
connector.
2. Staple Shift Motor is defective.
DA-
FS405/
FS356/
FS325
only
E7-27 Finisher Tray
Lift Motor
Finisher Tray Lift
Sensor does not
turn Off/On within a
predetermined time.
Finisher 1. Check the Stack Tray Paper Height
Detection Sensor, or Paper Hold Lever
Detection Sensor connectors.
2. Stack Tray Paper Height Detection
Sensor, or the Paper Hold Lever
Detection Sensor is defective.
3. Check the Lift Motor connector.
4. Lift Motor is defective.
5. PCB is defective. (Finisher Controller
PCB for DA-FS405/FS356/FS325 /
CONT PCB for DA-FS402/FS350/
FS320)
6. Lift Drive Gear is defective.
DA-
FS405/
FS402/
FS356/
FS325/
FS350/
FS320
E7-28 Finisher
Punch Motor
Finisher Punch
Home Position
Sensor does not
turn Off/On within a
predetermined time.
Finisher 1. Punch Home Position Sensor is
defective.
2. Punch Motor Lock Sensor is defective.
3. Finisher Controller PCB is defective.
4. Punch Motor is defective.
DA-
FS405/
FS356/
FS325
only
E7-29 Finisher
Punch Shift
Motor
Finisher Side
Registration Home
Position Sensor
does not turn Off/On
within a
predetermined time.
Finisher 1. Side Registration Home Position
Sensor is defective.
2. Finisher Controller PCB is defective.
3. Side Registration Motor is defective.