Feature Code Selection
LCD display
contrast
#145 To change the LCD display contrast.
M1N “-2”
M2N “-1”
M3N “0” (default)
M4N “1”
M5N “2”
Scale selection #147 The selected scale will be used when measurements are shown on the unit’s
display.
M1N “MILLIMETRES” (default)
M2N “INCHES”
Display interval #148 To set display interval for messages showed alternately.
M1N “1sec” (default)
M2N “2sec”
M3N “3sec”
M4N “4sec”
M5N “5sec”
Administrator
code
#151 To change the administrator code for mode restriction settings.
1. MMENUN A MBNM1NM5NM1N A MSETN
2. Enter the current administrator code. A MSETN
R The default administrator code is “0000”.
3. Enter a new 4-digit administrator code using 0-9. A MSETN
4. Enter the new administrator code again. A MSETN A MMENUN
Note:
R It is recommended that you change this administrator code from the default
administrator code.
Mode restriction
#154 To activate the mode restriction. See page 102 for details.
Change password #155 To change the password for feature programming via remote operation.
1. MMENUN A MBNM1NM5NM5N A MSETN
2. Enter the current password. A MSETN
R The default password is “1234”.
3. Enter a new 4-digit password using 0-9. A MSETN
4. Enter the new password again. A MSETN A MMENUN
Note:
R It is recommended that you change this password from the default password.
R This password is also used for feature programming via a web browser.
Maintenance time
#158 The unit will automatically activate for self-maintenance.
1. MMENUN A MBNM1NM5NM8N A MSETN
2. Enter the maintenance start time.
R The default time is “00:00”.
R If you selected 12-hour time entry (page 22), press MGN repeatedly to
select AM or PM.
R If you selected 24-hour time entry (page 22), the time is set using 24-hour
time entry.
3. MSETN A MMENUN
Note:
R Do not activate the unit during self-maintenance.
72
12. Programmable Features
To Next Page