Panasonic DP-MB251CX - Programmable Features; 12.1 Programming from the unit

12.1 Programming from the unit
1 MMENUN
2 Press MBN and the 3-digit code (page 71 to page 92).
3 Press the appropriate selection to display the desired setting.
R This step will vary depending on the feature.
4 MSETN
5 Press MMENUN to exit.
12.1.1 Basic features
Feature Code Selection
Date and time #101 Enter the date and time using the dial keypad. See page 22 for details.
Your logo #102 Enter your logo using the dial keypad. See page 22 for details.
Your fax number #103 Enter your fax number using the dial keypad. See page 23 for details.
Location
(DP-MB251CX
only)
#114 This setting must match your location.
M1N “MIDDLE EAST”
M2N “MALAYSIA”
M3N “ASIA” (except Middle East and Malaysia)
M4N “TUNISIA”
M5N “AFRICA” (except Tunisia)
Dialling mode #120 If you cannot dial (page 57), change this setting according to your telephone line
service.
M1N “PULSE”
M2N “TONE” (default)
Recall/Flash time #121 The recall/flash time depends on your telephone exchange or host PBX.
M0N “900ms”
M1N “700ms” (default)
M2N “600ms”
M3N “400ms”
M4N “300ms”
M5N “250ms”
M6N “200ms”
M7N “160ms”
M8N “110ms”
M9N “100ms”
MGN “90ms”
MBN “80ms”
Note:
R If the unit is connected via a PBX, PBX functions (transferring a call, etc.) might
not work correctly. Consult your PBX supplier for the correct setting.
ADSL mode
#124 When you use a DSL/ADSL line, this feature improves the reliability by reducing
the transmission speed.
M0N “OFF” (default)
M1N “ON”
Note:
R Calling charges may be higher than usual.
71
12. . Programmable Features
12. Programmable Features