7.2 More copying features
R Make sure that the MCOPYN light is ON.
7.2.1 Zoom copy (enlargement / reduction)
1 Set the original (page 35).
2 Press MZOOMN repeatedly to select the zoom rate
that fits the size of your document and recording
paper.
– “ZOOM =100%”
*1
– “50%”
– “200%”
*1
Press MCN or MDN repeatedly to change the zoom
rate by 1 % at a time from “25%” to “400%”.
You can also enter the desired percentage
specifically by using the dial keys.
3 MSETN
4 If necessary, enter the number of copies (up to 99).
A MxN
5 After you finish copying, press MwN to reset this
feature.
Note:
R Zoom copy is not available for the following features:
– Quick ID copy feature (page 48)
– Image repeat feature (page 48)
– Poster feature (page 49)
– N in 1 feature (page 50)
– Separate N in 1 feature (page 50)
– Booklet feature (page 51)
R You can hold the previous zoom setting (feature #468
on page 83).
R When using the scanner glass, the unit will enlarge
the image starting from the upper left corner of the
scanning glass starting from the
mark.
R When using the automatic document feeder, the
unit will only enlarge the centre of the document
entrance side of the document. To make an enlarged
copy of the other side of the document, turn the
document around, and then make a copy.
Example: 150 % enlarged copy
*1
Using the scanner glass (A):
Original document Enlarged copy
Using the automatic document feeder:
Original document
Enlarged copy
Example: 70 % reduced copy
*1
Using the scanner glass (A):
Original document
Reduced copy
Using the automatic document feeder:
Original document
Reduced copy
*1 The result for an A6 size original will differ since it
must be placed in portrait direction (page 35).
7.2.2 Duplex feature
The following types of copies are available:
– 1-sided originals to 2-sided copies
– 2-sided originals to 1-sided copies using the
automatic document feeder
– 2-sided originals to 2-sided copies using the
automatic document feeder
You then need to select the binding for originals and/or
copies.
46
7. Copier
To Next Page
Loading...
