1 If the MCOPYN light is OFF, turn it ON by pressing
MCOPYN.
2 Set the original (page 35).
3 MFN A “COLLATE”.
4 Press MCN or MDN repeatedly to display “ON”.
5 MSETN
6 Enter the number of copies (up to 99).
7 When using the scanner glass:
1. MxN
R The unit will scan 1 page.
2. Place the next document on the scanner glass
and press MSETN. Repeat this until you have
scanned all pages, and then press MxN.
R The unit will start copying.
When using the automatic document feeder:
MxN
8 After you finish copying, press MwN to reset this
feature.
Example: Making 2 copies of a 4-page original
document
Collated pages
Uncollated pages
Note:
R The unit will store the documents into memory at a
reduced resolution while collating the copies. If the
memory becomes full while storing, the unit will only
print out the stored pages.
R You can hold the previous collate setting (feature
#469 on page 83).
Proof set feature
To make 1 set of a collated copy first, press MCN or MDN
repeatedly to display “PROOF SET” (step 4 on
“7.2.3 Collate copy”, page 47). The unit will make 1 set
of a collated copy and stop temporarily so you can check
whether the copy was made as you expected. If the copy
is correct, press MxN to continue copying.
If the copy is not correct, press MwN and start again from
the beginning.
7.2.4 Quick ID copy feature / Image repeat
feature (Scanner glass only)
Quick ID copy feature: To copy 2-sided documents
onto one page.
Image repeat feature: To copy a single document
repeatedly onto one page.
1 Set the original (page 35).
R The scanning area changes according to the
selected setting in step 4. See the following table
for details. The shaded area will be scanned.
R You do not need to change the original document
size.
2 Press MPAGE LAYOUTN repeatedly to select “PAGE
LAYOUT”.
3 Press MCN or MDN repeatedly to select “QUIK ID
COPY” or “IMAGE REPEAT”. A MSETN
4 Press MCN or MDN repeatedly to select the number of
original documents from “2 in 1”, “4 in 1” or “8
in 1”. A MSETN
R For quick ID copy feature, go to the next step.
R For image repeat feature, go to step 6.
5 Press MCN or MDN repeatedly to select the page layout
from “LANDSCAPE” or “PORTRAIT”. A MSETN
6 If necessary, enter the number of copies (up to 99).
7 Quick ID copy feature:
1. MxN
R The unit will scan 1 page.
2. Place the next document on the scanner glass
and press MSETN. Repeat this until all the
documents are scanned.
R The unit will start copying.
R You can press MxN anytime to start copying.
Image repeat feature:
MxN
8 After you finish copying, press MwN to reset this
feature.
Note:
R This feature cannot be used when your original
document size or the recording paper size is set to
A6.
R This feature cannot be used when the duplex feature
(page 46), or ecology mode’s duplex (page 101) is
activated.
R The copied documents will not be reduced to fit the
recording paper. These features are useful for
copying small documents such as double sided ID
Cards or making multiple copies of small documents
such as a business cards.
R You can save the previous page layout setting
(feature #467 on page 83).
48
7. Copier
To Next Page
Loading...
