Feature Code Selection
Set all features to
default
#159 Before you dispose of, transfer or return the product, activate this feature to reset
all programmable features and to delete all data stored in memory.
Address book (or caller information) and fax transmission data (journal report and
faxes received in memory) will be deleted.
R Disconnect the telephone line cord, USB cable and LAN cable before
activating this feature.
M0N “NO” (default)
M1N “YES”
To reset all features:
1. MMENUN A MBNM1NM5NM9N
2. M1N A “YES” A MSETN
3. M1N A “YES” A MSETN
Ringer pattern
#161 To set the ringer pattern.
M1N “A” (default)
M2N “B”
M3N “C”
Beep sound #165 To set the beep sounds and keytones. If you wish to hear confirmation/error beep
sounds and keytones, activate this feature.
M0N “OFF”
M1N “ON” (default)
Note:
R Even if this feature is set to “OFF”, the unit beeps in some cases. For example:
– the memory reception alert setting (feature #437 on page 81) is
activated.
– the front cover is opened.
Job end
notification
#174 To set the unit to alert you with a beeping sound after a print job is finished.
M0N “OFF” (default)
M1N “ON”
Note:
R This setting is valid for the following:
– PC printing
– Automatic report/list printing during fax transmission
– Printing received faxes
R When a printing error occurs, the unit will beep the error beep instead of this
beep, even if this feature is set to “ON”.
FAX ring count
#210 To change the ring count in FAX ONLY mode.
M1N “1”
M2N “2” (default)
M3N “3”
M4N “4”
M5N “5”
M6N “6”
M7N “7”
M8N “8”
M9N “9”
Note:
R If you are using the unit with an answering machine, set to more than 4
(page 62).
73
12. Programmable Features
To Next Page
Loading...
