Panasonic DP-MB251CX - Page 80

Feature Code Selection
Delivery notice #426 When “ON” is selected, a delivery notice is sent to the receiver of the Internet fax.
If the receiver returns the notice, a sending report will be printed.
M0N “OFF”
M1N “ON” (default)
POP timer setting #428 To set the POP timer.
1. MMENUN A MBNM4NM2NM8N
2. Set the POP timer (the interval of receiving Internet fax automatically) to a
value between “00” and “60” minutes using the dial keypad.
R The default is “03” minutes.
R If you do not want to receive an Internet fax automatically (page 67), set
the timer to “00”.
3. MSETN A MMENUN
Fax send notify
#429 To set the unit to alert you with a beeping sound after fax transmission is finished.
M0N “OFF” (default)
M1N “ON”
Activating the
Distinctive Ring
feature
#430 M0N “OFF” (default)
M1N “ON”
Note:
R This feature may not be available depending on feature #114 setting
(page 70) (DP-MB251CX only).
See page 70 for details.
Setting the ring
pattern for fax
(Distinctive Ring
feature)
#431 M1N “A”
M2N “B”
M3N “C”
M4N “D”
M5N “B-D” (default)
Note:
R This feature may not be available depending on feature #114 setting
(page 70) (DP-MB251CX only).
See page 70 for details.
Auto reduction
#432 To receive a fax document that is longer than your recording paper. When “ON”
is selected, the unit will fit received documents onto your recording paper.
M0N “OFF”
M1N “ON” (default)
Fax activation
code
#434 If you wish to use an extension telephone to receive faxes, activate this feature
and program the activation code.
M0N “OFF”
M1N “ON” (default)
Important:
R The fax activation code must be different from the code that you
programmed on the answering machine.
To change the fax activation code
1. MMENUN A MBNM4NM3NM4N
2. M1N A “ON” A MSETN
3. Enter your code from 2 to 4 digits, using 0-9, MGN and MBN.
R The default code is “H#9”.
4. MSETN A MMENUN
80
12. Programmable Features