12.1.5 Scan features
Feature Code Selection
Scan mode #493 To set the scan mode for Push Scan. See page 42 for details.
M1N “VIEWER” (default)
M2N “FILE”
M3N “EMAIL”
M4N “OCR”
M5N “EMAIL ADDRESS”
M6N “FTP SERVER”
M7N “SMB FOLDER”
Note:
R Following selections will be displayed only when the server setting is
programmed through the web browser interface in advance.
– “EMAIL ADDRESS” (page 94)
– “FTP SERVER” (page 94)
– “SMB FOLDER” (page 95)
Scan parameter
hold
#494 To hold the previous scanning parameter for Push Scan. When “ENABLED” is
selected, the unit will hold the previous scan settings for each mode of push scan.
M0N “DISABLED” (default)
M1N “ENABLED”
87
12. Programmable Features
To Next Page
Loading...
