Feature Code Selection
Network status #526 To view the network status. See page 115 for details.
IP filtering #532 When “ENABLED” is selected, the unit will deny/approve access from the
pre-programmed IP patterns. You can program whether to deny or approve IP
addresses. Up to 4 patterns each for IPv4 and IPv6 can be programmed through
the web browser interface (page 95).
M0N “DISABLED” (default)
M1N “ENABLED”
Auto IP #533 To set the IP address automatically for the LAN connection. This feature is
available when feature #500 is activated. When “ENABLED” is selected, IP
address will be allocated automatically without using a DHCP (Dynamic Host
Configuration Protocol) server.
M0N “DISABLED” (default)
M1N “ENABLED”
HTTPD #534 To set HTTPD for the LAN connection. When “ENABLED” is selected, you can
access to the web server.
M0N “DISABLED”
M1N “ENABLED” (default)
IPv6 protocol #535 When “ENABLED” is selected, IPv6 protocol can be used. After installing the
printer driver, be sure to change the port to IPv6 protocol. You can check the IPv6
protocol address by printing the “SETUP LIST” (page 100).
M0N “DISABLED” (default)
M1N “ENABLED”
Note:
R To activate this feature, you need to turn the power switch of the unit OFF,
then ON.
WINS server #1
#538 To set the primary WINS server for the LAN connection. This feature is available
when feature #500 is deactivated.
1. MMENUN A MBNM5NM3NM8N A MSETN
2. Enter the primary WINS server of the network on the LAN using the dial
keypad. A MSETN A MMENUN
WINS server #2 #539 To set the secondary WINS server for the LAN connection. This feature is
available when feature #500 is deactivated.
1. MMENUN A MBNM5NM3NM9N A MSETN
2. Enter the secondary WINS server of the network on the LAN using the dial
keypad. A MSETN A MMENUN
Address book
editing on web
#567 When “ENABLED” is selected, you can check and edit the address book through
the web browser interface (page 98).
M0N “DISABLED”
M1N “ENABLED” (default)
Caller ID list on
web
#568 When “ENABLED” is selected, you can check the Caller ID list through the web
browser interface (page 101).
M0N “DISABLED”
M1N “ENABLED” (default)
Journal on web #569 When “ENABLED” is selected, you can check the journal report through the web
browser interface (page 101).
M0N “DISABLED”
M1N “ENABLED” (default)
89
12. Programmable Features
To Next Page
Loading...
